The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

I want to use interconnect studio. I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」 ...

Yes, we can transfer the data like indicated but not sure this is the most optimal option. Can you please explain what you are trying to do? On the camera side what serializer are you going to use?

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

28335 tx to RS232 converter tx to (connected DB9 connecter) to DB9 connecter tx to DB9 connecter rx to RS232 rx to TMS320F28069 rx 28335 rx to RS232 converter rx to (connected DB9 connecter) to DB9 ...

When the TX_PLL of AFE7769 is set at 880MHz, a large power DC will be generated, and the QMC automatic calibration cannot go down, affecting the ACPR, this problem has a small probability, about 1/250 ...

I am working towards answering your question, but the lab work required will take me a bit of time. I will have an answer for you by the end of the week. There is no ripple specification that has been ...

We used AWR2243P to realize chip cascade before, but now we can only buy AWR2243 from TI Mall and authorized distributors. It is clearly stated on TI official website and the product description of ...

TPS61165DRVRG4 is constant current LED driver. The LCD module backlight has a spec for both voltage and current. for example, our backlight has a current spec 180mA and voltage spec typ 9.6V, max10.2V ...

We have found LM5064 for the solution. As per the datasheet page#21 to maintain accuracy, the sense resistor voltage should not be less than 3 mV. But our calculated Vsense voltage comes near 1.5mV.

I am asking this for our customer. F280013x is in I2C target. In some cases, F280013x may have sent a byte by writing the byte onto I2CDXR but gets STOP from the controller, so the byte is in I2CXSR ...